1963-67 Corvette, Coated Steel, EFI, Gas
Holley and Sniper will help you to complete your EFI swap with our new EFI Conversion Fuel Tanks. Each tank is a direct fit for your application-no modifications necessary. The kit includes the tank, a 255 lph fuel pump, internal baffling and a fuel level sending unit. The tank is powder coated for corrosion resistance and great looks. These tank kits are a complete solution for your EFI project! ***You must use your existing stock filler neck or purchase one through restoration suppliers. ***This kit includes a fuel gauge sender for use with FACTORY FUEL GAUGE and wiring. If you are using an aftermarket gauge, you will also need a sending unit for that gauge ohm range. Supports up to 550 EFI (@ 60 PSI at 13.5 Volts / 10.4 AMP Draw) Size is: 38" x 15-3/4" x 11-3/4"
Install Notes:For a better seal use Permatex Indian Head Gasket Shellac Compound or Aviation Form-A-Gasket sealant on the gasket and screws. ***This kit includes a fuel gauge sender for use with FACTORY FUEL GAUGE and wiring. If you are using an aftermarket gauge, you will also need a sending unit for that gauge ohm range. Ohms test first number is empty, the second number is full Sender & 12v = 2-120 ohms Sender & Ground = 120-2 ohms 12v & ground = 120 ohms constant *** Kit includes a strap spacer to go over sending unit when installing fuel tank strap (pictured).
CA Residents: WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov
