These 1.5" diameter spacers are precision-machined from high-grade steel and then nickel-plated for long-lasting durability. Two washers (one for each side of the bolt) are included in each kit. Installation is very simple and no special tools are required. The two washers install at each end of rearmost bolt for the driver's side lower control arm.
Note 1: It is recommended that the truck be aligned following the installation of these clunk washers.
Note 2: In some instances, it appears that Ford used a control arm bolt with the same thread but a slightly larger OD. The fit of the washer over the fastener is tight by design, but some trucks using this particular bolt with the taller threads may require a slight honing of the ID of the washers for proper installation.
Beefcake Racing is an Authorized Dealer for Metco Motorsports, call 1-855-827-7223, 9am-9pm EST
CA Residents: WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov