These billet control arms are cnc machined from massive blocks of 6061 aircraft aluminum, making them both lighter and much stronger than stock. The perfect set up for a bullet proof rear suspension; for the off-roader and drag racer alike.
Utilizing massive 1" FK stainless spherical bearings with Teflon liner for a long trouble-free life of drag strip launches and full sends through dirt and sand. The Cab side has wobble stoppers built into the arm, while the axle end has high misalignment spacers. Reducing deflection while allowing for maximum rear end articulation. These spherical joints have a dynamic load rating of over 56,000 lbs.....each, and are retained by 3 layer stainless steel spiral rings. These arms consists entirely of anodized 6061 Aluminum and stainless steel which means NO RUST!
All the performance and looks of competitive arms but at a fraction the price!
They also include removable stainless ride height sensor balls to retain factory electronic shock functionality.
Kit Includes:
- (2) Rear lower control arms
- (2) Rear upper control arms
- (2) Ride Height Sensor balls
- All necessary bearing spacers (pre-installed)
- Wobble Stoppers (Pre-installed)
This all arrives to your door in our typical precision laser cut foam packaging!
* Factory Hardware is re-used
Available in black, red, and clear anodize
CA Residents: WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov
