Strange Engineering Evolution Dynamic Drive Mount Drag Race Front Brake Kit 4 1/2" BC (1967 - 1969 Mustang / Ford) - B4135WCE

Part Number: B4135WCE

 
Designed Specifically For Drag Racing

Evolution Front Brake Kit
1966-1969 Fairlane
1966-1969 Falcon
1967-1969 Mustang
1967-1969 Ranchero
1966-1969 Comet
1967-1969 Cougar

 

All Above with Factory Drum Brake Spindles

Evolution S Dynamic Drive Mount (DDM) Stainless Steel Rotors – B2798L / B2798R
• Evolution S Rotor mounts to Billet Aluminum DDM Hat – reducing rotating weight
• DDM system secures the rotor and allows for rotor thermal expansion – drastically reducing warping, coning, and cracking which are common with bolt retention designs
• DDM system design is secured by an internal Spirolox, eliminating heavy bolts and hardware- further reducing rotating weight
• Evolution S rotors are machined and fully ground from Stainless Steel that exhibits 48% greater yield strength at 1,000° F compared to carbon steel- further maintaining rotor integrity
• Stainless steel Evolution S rotors are highly resistant to heat and corrosion
• Unique Aero Slot design reduces rotating weight and promotes even heat dissipation- compared to common round drilled holes
• Scalloped design further reduces rotating weight
• 11.250? OD / .355? thickness

 

Four Piston Billet Evolution 4 Calipers – B1900
• Computer finite element analysis (FEA) optimized and field-tested caliper
• Evolution 4 design improves piston retraction, pedal feel, and stiffness
• High retraction piston and O-ring design to eliminate drag during acceleration
• Results in improved pad wear and exemplary braking efficiency
• Stainless steel pistons mitigate heat transfer to brake fluid
• All 1.750? pistons provide maximum clamping force
• Two bleeder screws ensure complete air evacuation
• Type II Black anodized finish resists corrision, heat & brake fluid

 

Aluminum Caliper Mounts
• Billet one piece design
• Eliminates bolts, spacers & nuts that require periodic maintenance

B5010
• Best compound suited for front application
• Excellent cold holding capabilities

 

Billet Aluminum Hubs
• Strong lightweight material
• Lightening holes for enhanced weight reduction
• Billet hub caps with O-rings
• Bearings, races and seals

 

Screw-in Wheel Studs – A1028
• Tapered allen 1/2?-20 x 2 1/2?
• Standard allen in 3? available on request

All Necessary Mounting Hardware

 

Need More Wheel Clearance?
Low Profile Caliper Option – OPRB12

 

Brake Hoses and Lines Are Not Included
Calipers are tapped 1/8? NPT and supplied with a straight male 3 AN fitting

Use Teflon® tape or liquid on the pipe threads of the fitting
Leave a few threads from the tip uncoated
This will avoid depositing material inside the caliper
Torque fitting to 25 ft lbs