Snow Performance Holley High Ram Plenum Plate Direct Port Water-Methanol Injection System with VC-50 Controller – No Tank SNO-940-BRD-T
Unlock up to 70 horsepower and slash intake temperatures by as much as 100°F with the Snow Performance Stage 2.5 Boost Cooler system. Designed for supercharged and turbocharged builds, this direct port water-methanol injection kit delivers precise control and cooler combustion for more efficient power. The VC-50 controller (52mm gauge) adjusts injection rates based on boost pressure, allowing tuners to dial in start and full points for a custom delivery curve tailored to engine load.
Ideal for street/strip setups and especially beneficial for direct-injected engines, this system helps eliminate carbon buildup while boosting pump gas octane by up to 25 points. The VC-50 doubles as a digital boost gauge and injection controller, featuring a vivid OLED display with seven selectable colors (Blue, White, Red, Yellow, Orange, Purple, Green). It shows boost pressure, injection percentage, fluid level alerts, stage activation, prime status, and fault codes—all in one compact interface.
At the heart of the kit is Snow’s OEM-approved 300 PSI UHO pump, built for extreme environments with sealed O-ring connections and proprietary internals that resist heat and moisture. Unlike sleeve-style pumps that trap heat and corrode over time, this unit is engineered for long-term reliability. The system includes 100% methanol-resistant components—stainless steel, nickel-plated fittings, EPDM seals, and hard anodized aluminum—plus Snow’s ACU-SEAL compression fittings for leak-free operation even with pure methanol.
Whether you're running a turbo, centrifugal supercharger, or high-compression setup, the Stage 2.5 Boost Cooler helps deliver a colder, denser charge and can raise 91-octane fuel to race-ready 116-octane levels.
Kit Features:
- Made in the USA
- Progressive water-methanol control with RPM/boost mapping
- VC-50 controller with 7-color OLED display (1–50 PSI boost readout)
- Ideal for turbocharged and centrifugal supercharged street builds
- Supports over 1,000 horsepower
- 100% methanol-resistant materials (SS, nickel plating, EPDM, anodized aluminum)
- Includes 8 x #2 Hyper-Sonic nozzles
- ACU-SEAL compression fittings for leak-free plumbing
- OEM-approved 300 PSI UHO pump with sealed housing
- Low-profile engraved nozzle holder and high-flow check valve
- Snow Performance solenoids
- Stainless hardlines pre-plumbed on Holley High Ram plate
- Tank not included
CA Residents: WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov
